SCAN TOOL DIAGNOSTICS no abs light was on during start up. while test drive, abs lights came on. scan data shows code C2200 anti lock brake module internal. the module monitors for internal microprocessor operation. if internal fault is detected it will set code. manufacture procedure is to erase code and res can to determine if code comes back. code was erased and did not come back immediately. this indicates a possible intermittent issue cause but bad grounds, or wiring. at this time it is recommended to clean all grounds and test drive to determine if code comes back on. if code comes back on the abs module will need to be replaced and reprogrammed.
CLEANING THE GROUNDS AND CONNECTION
ERIC M. gave our service a 5 star review on 11/8/2021
A/C COMPRESSOR – Remove & Replace – 2.4L Eng – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
PULL VACUUM
CHARGE AC
FLUSH AC UNIT
CONDENSER – Remove & Replace – 2.4L Eng – [Includes: R&I Front Bumper Cover. DOES NOT include drain and refill Transmission Fluid or Fluid Level check.] – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
DIAGNOSTICS- needs belt , tensioner, and idler pulley for noise.
ALLISON P. gave our service a 5 star review on 7/21/2021
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
CHANGE OIL AND FILTER
ANGELIQUE M. gave our service a 5 star review on 6/2/2021